This command tells you about devices connected to the system. Give the system a few seconds to ‘see’ the disks, then enter the following: lsblk Using the powered USB 3.0 hub connected to your Raspberry Pi, plug in all your USB disk drives.
#RASPBERRYPI DENEMO UPDATE#
Finally, make sure everything is up-to-date with sudo apt update & sudo apt -y upgrade, then reboot. We imaginatively changed ours to ‘nas’, so the network address is ‘nas.local’.
#RASPBERRYPI DENEMO PASSWORD#
Finally, change your password and, under Network Options, change the Hostname (the NAS’s network name) if you wish. If you wish, configure WiFi at this point, but for a decent NAS you’ll ideally be using the lovely full-speed Gigabit Ethernet port. Once booted, make sure SSH has been enabled by running sudo raspi-config and selecting Interfacing Options > SSH. Step 03: Prepare the OSĭownload Raspbian Buster Lite and burn it to a microSD card. For reliable power we added a powered USB 3.0 hub. We decided on 1 terabyte of storage, meaning two 1TB external drives. To provide a layer of protection, you’ll need to double the number of drives to make sure your data is safer. Raspberry Pi 4 offers USB 3.0, so make sure you get external USB drives that take advantage of that extra speed. Rotary drives give us lower cost and higher capacity than SSDs. The design of Raspberry Pi means using external USB disks. The most important decision you’ll make is how much storage you’ll need. In simpler terms, it’s a box on to which you dump all your movies, photos, music, and other stuff so you can get to it wherever and whenever. The files themselves should be available with appropriate security measures over desired protocols. That means it should protect against system failures that cause significant downtime, and make sure no data is lost as a result of those failures. It must also offer availability and resilience for your data. So what is a NAS, anyway? A well-implemented, network-attached storage device is typically a headless device (no keyboard or monitor) providing access to large amounts of data from anywhere on your network. 2 × External USB drives (minimum), e.g.This article first appeared in The MagPi 85 and was written by PJ Evans You'll need Now, thanks to the improved throughput of Raspberry Pi 4 with USB 3.0 and Gigabit Ethernet, you can build a fully featured NAS for a fraction of the cost.
#RASPBERRYPI DENEMO PROFESSIONAL#
These file- and media-serving black boxes can punch a hole in your bank account, particularly the professional versions aimed at businesses. Getting access to those files and making sure they are protected from drive failure can be challenging without an expensive network-attached storage (NAS) solution. If you’ve got a lot of files like photos, music, or movies, chances are they are sitting on a hard drive somewhere.
0 kommentar(er)
